General Services

Included In Our Sterndrive and Outboard Services In Addition To The Engine and Drive Service

  • Service,Charge, and Test All Batteries, Check Navigation and Anchor Lights, Check Bilge Pump and Blower, Check All Additional Accessories.  Air Up Trailer Tires and Lube Greasable Trailer Hubs.

Outboard Service - General 2 & 4 Stroke Engines

Have An Outboard Hanging Off The Back?  Keep It Turn Key and Never Miss a Day On The Water!

2-Stroke Engines

  • Check Compression
  • Inspect & Replace Spark Plugs As Needed
  • Check Timing Setup & Carburetor Sync
  • Change Fuel Filter(s) - Inspect for Contaminants
  • Check Fuel & Oil Systems for Deterioration Or Leaks
  • Inspect Thermostat Visually - Clean Corrosion
  • Inspect Belt Tensioner & Belt
  • Inspect & Lube Throttle & Shift Cables
  • Check & Tighten Transom Bolts & Motor Mounts
  • Check Power Trim Fluid
  • Inspect Overall - Wiring, Hoses, Clamps, Fittings & Tubing



Lower Unit

  • Remove Propeller & Inspect For Damage To Blades
  • Pull Lower Unit
  • Change Gear Oil & Inspect for Contaminants
  • Pressure Check Lower Unit If Needed
  • Replace Water Pump Impeller
  • Inspect Impeller Housing & Surfaces
  • Inspect Prop Shaft & Drive Shaft
  • Lubricate All Splines On Prop Shaft & Drive Shaft



                                  Additional Checks and Inspection During Outboard Service

  • Service & Charge Batteries
  • Load Test Batteries Condition
  • Treat Fuel & Inspect Fuel Lines
  • Hydraulic Steering: Inspect For Leaks & Check Fluid Level
  • Cable Steering : Clean & Grease Steering
  • Lube All Lubrication Points
  • Check Corrosion Control Anodes



Even though it would be great if all you needed was basic service for your outboard, we offer an extensive amount of repairs to meet your demands. Whether you need a basic part replaced or a power head repaired we have the right tools and equipment to get you boating again. We can rebuild trim cylinders, replace cables and controls, bleed your steering, diagnose electrical and fuel problems or rebuild your lower unit and power head. We meet the tasks you need and handle each with the expert knowledge and training.

Sterndrive Service

Keep That I/O Running Strong With Yearly Maintenance and Tune Ups













Additional Checks and Inspections

  • Service &Charge Batteries
  • Load Test Batteries Condition
  • Check Bilge Blower
  • Check Bilge Pump
  • Check Navigation & Anchor Light
  • Check Additional Accessories
  • Test Run Engine Package
  • Scan For Runtime and Service Codes
  • Print Runtime Sheet
  • Basic Trailer Service and Inspection

















  • Engine Service: Includes Oil and Filters, Service Seawater Pump, Clean Flame Arrestor, Service and Charge Batteries, Inspect Belts and Hoses, Diagnostic Scan, and Ignition and Fuel System Inspection.Closed Cooling Inspection If Equipped.
  • Drive Service: Includes Drive Pull. Alignment, U-joints, Gimbal Bearing and Coupler Inspection. Lube U-joints, Gimbal Bearing, and Coupler. Drive Oil Change (Including Lube Monitor Flush) Inspection of Propeller and Propshaft, Inspection and Retorque of Gimbal Ring. Trim System Inspection.
  • General Tune Up: Spark Plugs, Spark Plug Wires, Distributor Cap and Rotor, Ignition Module. We Offer Tune Ups For All Sterndrive Models and Manufacturers, Call Today To Schedule an Appointment.

Services Offered to Meet your Needs

4-Stroke Engines

  • Inspect & Replace Spark Plugs As Needed
  • Check Compression If Needed
  • Drain & Change Engine Oil  
  • Replace Oil Filter(s)
  • Change Fuel Filter(s) - Inspect for Contaminants
  • Check Fuel & Oil Systems for Deterioration Or Leaks
  • Inspect Thermostat Visually - Clean Corrosion
  • Inspect Belt Tensioner & Belt
  • Inspect & Lube Throttle & Shift Cables
  • Check & Tighten Transom Bolts & Motor Mounts
  • Check Power Trim Fluid
  • Inspect Overall - Wiring, Hoses, Clamps, Fittings & Tubing

Engine Service

  • Change Engine Oil & Filter
  • Change Fuel Filters
  • Change Impeller- Resurface Housing
  • Clean Flame Arrestor
  • Check & Tighten Motor Mounts
  • Inspect Belts and Hoses
  • Check Fuel System and Ignition System
  • Inspect and Lube Overall
  • Test Run and Scan Motor With CDS
  • Check Bilge Pump
  • Check Navigation & Anchor Light
  • Check Additional Accessories
  • Test Run Engine Package
  • Scan For Runtime and Service Codes
  • Print Runtime Sheet
  • Basic Trailer Service and Inspection

Tune Up (additional cost over service)

  • Spark Plugs
  • Ignition Wires
  • Cap & Rotor
  • Ignition Module



Drive Service

  • Pull Outdrive
  • Check Alignment
  • Inspect U-Joints, Bellows, Gimbal Bearing
  • Lube U-Joints, Bellows, Gimbal Bearing
  • Inspect Propeller & Propshaft
  • Install & Torque Outdrive
  • Change Gear Oil
  • Flush Lube Monitor
  • Inspect Trim System, Fluid Level, Rams Lines
  • Inspect & Torque Gimbal Ring